|RCBS Limited Production Bullet Moulds are constructed of the best quality of Pearlitic malleable iron. The blocks are ground to achieve an exact tolerance. The locating pins are case hardened to limit wear and to provide permanent alignment for the bullet cavities. Bullet cavities are machined to form a perfect match. The Sprue cutter is a solid steel plate that has been machined to hold firmly against the mould block with an adjustable pressure washer. RCBS, Saeco, and Lyman 4 cavity handles will normally fit RCBS moulds. Bullet mould handles not included. HDS does not stock the Limited-Production pistol moulds, 90-120 day turn around from RCBS.
8mm-110-RN CS Nambu
455 Webley 265-RN HB
Most are Double Cavity design except where noted.
+ Single Cavity Mould
# Gas Check applicable
BB - Bevel Base | BPS - Black Powder Silhouette
CAV - Cavalry | CM - Cowboy Mould | CN - Conical Nose
SPL - Special | CSA - C Sharps Arms | FN - Flat Nose
K - Keith Type | M - Minie Ball | PT - Pointed
R - Round Ball | RN - Round Nose | SAA - Single Action Army
SIL - Silhouette | SP - Semi-Point | SWC - Semi-Wadcutter TG - Target | U - Universal | WC - Wadcutter
See Reference Section for Bullet Mould description [PDF] (see HDS Catalog page 86)
If the mould is not listed below, consult the Standard Pistol Bullet Mould section.
California Prop. 65 Warning:
Melting lead and casting lead objects (with these products) will expose you and others in the area to lead, which is known to cause birth defects, other reproductive harm, and cancer.